VDCCM Parameter Check

NOTE: The parameter data registered in the VDCCM is shown on the display.

Perform confirming on parameter.
1. Connect the Subaru Select Monitor to data link connector.
  NOTE: For detailed operation procedures, refer to "Application help".
2. Turn the ignition switch to ON.
3. On «Start» display, select «Diagnosis».
4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
5. On «Main Menu» display, select «Each System».
6. On «Select System» display, select «Brake Control System» and select «Enter».
7. On «Select Function» display, select «Work Support».
8. On «Work Support» display, select «Confirm on parameter».
Check that the applied model and grade of the relevant vehicle are included, and click the «OK» button.
If the applied model and grade of the target vehicle are not included, perform "parameter selection and registration". < Ref. to VDCCM PARAMETER SELECTION , MAINTENANCE MODE, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). >