Adjustable Anchor ASSY

Install the trim panel - rear pillar UPR.
NOTE: Assemble the trim panel - center pillar LWR to the trim panel - center pillar UPR securely.

Fig 1: Installing Trim Panel - Rear Pillar UPR
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Trim panel - center pillar UPR: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the trim panel - center pillar LWR.
Install the trim panel - center pillar LWR, cover side sill - front INN, and cover side sill - rear INN.
Install the rear seat cushion assembly.
Connect the battery ground terminal. < Ref. to BATTERY , NOTE, Note. >
NOTE: For models other than STI model, connect the ground terminal to battery sensor.
After installation, check the following points.
- The seat belt is not twisted.
- The seat belt can be pulled out and retracted smoothly.
- The adjuster assembly - seat belt can be moved smoothly.
- Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON.