DTC P0336: Crankshaft Position Sensor "A" Circuit Range/Performance: Notes
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
- Engine stall
- Failure of engine to start
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to
OPERATION
, Clear Memory Mode., and Inspection Mode Ref. to
PROCEDURE
, Inspection Mode..
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR. Turn the ignition switch to OFF. |
Is the crankshaft position sensor installation bolt tightened securely? | Go to step 2 . | Tighten the crankshaft position sensor installation bolt securely. Ref. to INSTALLATION , Crankshaft Position Sensor. |
| 2 CHECK CRANKSHAFT POSITION SENSOR PLATE. | Is there crack or damage in the crankshaft position sensor plate teeth? | Replace the crankshaft position sensor plate. Ref. to Cylinder Block . | Go to step 3 . |
| 3 CHECK INSTALLATION CONDITION OF TIMING CHAIN. Turn the crankshaft using ST, and align the alignment mark on crank sprocket with alignment mark on cylinder block. ST 18252AA000 CRANKSHAFT SOCKET |
Is the timing chain dislocated from its proper position? | Correct the installation condition of timing chain. Ref. to Timing Chain Assembly . | Replace the crankshaft position sensor. Ref. to Crankshaft Position Sensor . |