Engine Control Module (ECM): Installation

Install in the reverse order of removal.

CAUTION:

When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system.
- For model without keyless access with push button start, refer to the Type B in "REGISTRATION MANUAL FOR IMMOBILIZER".
- For model with keyless access with push button start, refer to the Type D in "REGISTRATION MANUAL FOR IMMOBILIZER".
If replacing ECM or the bracket, replace both parts with new parts at a time.
After installing the bracket to ECM, do not separate the bracket.
If the bracket has been installed to ECM in the wrong direction, replace both parts to new parts.

NOTE: When replacing the ECM, be careful not to use the ECM of wrong specification to avoid any damage on the fuel injection system.

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)