Active Test: Operation
CAUTION:
After executing the system operation check mode, execute the Clear Memory Mode. Ref. to
OPERATION , Clear Memory Mode.
NOTE:
- *: After replacing ECM, be sure to perform this procedure.
- For detailed operation procedures, refer to "Application help".
- On «Start» display, select «Diagnosis».
- On «Vehicle selection» display, input the vehicle information and select «Confirmed».
- On «Main Menu» display, select «Each System».
- On «Select System» display, select «Engine Control System».
- On «Select Function» display, select «Active Test».
| Active test items | Contents | Execution condition | ||||
|---|---|---|---|---|---|---|
| Fuel Pump Relay | ON/OFF of the fuel pump can be set. | Ignition switch is ON (engine OFF) | ||||
| CPC Solenoid Valve | ON/OFF of the purge control solenoid valve can be set. | |||||
| Radiator Fan Relay | ON/OFF of the radiator fan relay can be set. | |||||
| A/C Compressor Relay | ON/OFF of the A/C relay can be set. | |||||
| ELCM switching valve | ON/OFF of the leak check valve assembly switching valve can be set. | |||||
| ELCM pump | ON/OFF of the leak check valve assembly vacuum pump can be set. | |||||
| Fuel Pump Control (OFF Drive) | Fuel pump can be set to OFF. | At idling | ||||
| Fixed Idle Ignition Timing | Idle ignition timing can be set and fixed to 16.0°(1). | At idling | ||||
| Idle Speed Control | Idle speed can be set to 500 - 2000 rpm. | At idling | ||||
| Injection Stop Mode (Injector 1) Injection Stop Mode (Injector 2) Injection Stop Mode (Injector 3) Injection Stop Mode (Injector 4) |
Injector of each cylinder can be set to stop the fuel injection. | At idling | ||||
| Injection Quantity Control | The amount of fuel injection can be set to 0 - 20%. | At idling | ||||
| EGR Valve Control | EGR control valve can be set to 0 - 255 STEP. | At idling | ||||
| Alternator control | Alternator control mode can be set to one of the followings: Low mode Middle mode High mode (2) ExHigh mode |
At idling | ||||
|
||||||