LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2017 >> Crosstrek Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostics - Introduction) (H4DO) >> Inspection Mode >> Procedure >> SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

SUBARU Select Monitor

  1. Check that no DTC remains after clearing memory. Ref. to CLEAR MEMORY MODE .
  2. Warm up the engine.
  3. Prepare the Subaru Select Monitor kit. Ref. to PREPARATION TOOL , General Description.
  4. Prepare PC with Subaru Select Monitor installed.
  5. Connect the USB cable to the DST-i and the USB port on the personal computer (dedicated port for the Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  6. Connect the diagnosis cable to DST-i.
  7. Install the delivery (test) mode fuse (A).
    CAUTION: Do not use any fuses that are installed on the vehicle.
    Fig 1: Delivery (Test) Mode Fuse
    G08315886Courtesy of SUBARU OF AMERICA, INC.
  8. Connect the DST-i to the data link connector located in the lower portion of the instrument panel (on the driver's side).
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
    Fig 2: Locating Data Link Connector
    G08315883Courtesy of SUBARU OF AMERICA, INC.
  9. Start the PC.
  10. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  11. On «Start» display, select «Diagnosis».
  12. On «Vehicle selection» display, input the vehicle information and select «Confirmed».
  13. On «Main Menu» display, select «Each System».
  14. On «Select System» display, select «Engine Control System» and then select «Enter».
  15. On «Select Function» display, select «Dealer Check Mode Procedure» and then select «Enter».
  16. When «Perform Inspection (Dealer Check) Mode?» is shown on the screen, click the «Next» button.
  17. Perform subsequent procedures as instructed on the display screen.
NOTE:
  • For detailed operation procedures, refer to "Application help".
  • For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)". Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
  • Release the parking brake.
  • The rotating speed difference between front and rear wheels may illuminate the warning light, but this does not indicate a malfunction. When engine control system diagnosis is finished, perform the VDC memory clearance procedure of self-diagnosis function. Ref. to Clear Memory Mode .
scientia non olet · About LEMON Manuals