LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2017 >> Outback 2.5i >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Keyless Entry System >> Inspection >> Check Keyless Entry Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Keyless Entry Control Module

Step Check Yes No
1 CHECK BODY INTEGRATED UNIT. 
Read the DTC using Subaru Select Monitor.
NOTE: For detailed operation procedures, refer to "Application help".
 Is DTC U1500 "KEYLESS UART COM. MALFUNCTION" displayed? Go to step 2  . Keyless entry control module is normal.
2 CHECK POWER SUPPLY. 
  1. Disconnect the keyless entry control module connector.
  2. Measure the voltage between keyless entry control module connector and chassis ground.

Connector & terminal 
(R221) No. 6 (+) - Chassis ground (-): 		 Is the voltage 10 V or more? Go to step 3  . Check the harness for open or short circuits between the keyless entry control module and the fuse.
3 CHECK GROUND CIRCUIT. 
Measure the resistance between keyless entry control module connector and chassis ground.
Connector & terminal 
(R221) No. 5 - Chassis ground: 
(R221) No. 4 - Chassis ground: 		 Is the resistance less than 10 Ω? Go to step 4  . Repair or replace the harness.
4 CHECK KEYLESS ENTRY CONTROL MODULE CIRCUIT. 
  1. Disconnect the body integrated unit connector.
  2. Check the harness between keyless entry control module and body integrated unit.

Connector & terminal 
(i81) No. 10 - (R221) No. 11: 		 Is harness normal? Replace the keyless entry control module. Repair or replace the harness.
scientia non olet · About LEMON Manuals