LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2017 >> Outback 2.5i >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Steering Lock Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Lock Control Module: Installation

CAUTION:
  • When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to "Type D" described in "REGISTRATION SERVICE INFORMATION FOR IMMOBILIZER".
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).>
  1. Secure the steering lock CM to the steering column.
  2. Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).
  3. Install the column assembly - steering.
  4. Install the universal joint assembly - steering. <Ref. to INSTALLATION , Universal Joint.>
  5. Install the cover assembly - instrument panel LWR driver. <Ref. to INSTALLATION , Instrument Panel Lower Cover.>
  6. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
scientia non olet · About LEMON Manuals