Pulsation Damper RH

Remove the collector cover.
1. Carefully pull up the rear of collector cover at two positions (A).
2. Carefully pull up the front of collector cover at two positions (B) while moving it forward.
Fig 1: Removing Collector Cover
Courtesy of SUBARU OF AMERICA, INC.
Release the fuel pressure. <Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel.>
Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Open the fuel filler lid and remove the fuel filler cap.
NOTE: This operation is required to release the inner pressure of the fuel tank.
Loosen the clamp (A) securing the air intake boot.
Remove the bolt (B) securing the air intake boot to the collector cover bracket.

Fig 2: Air Intake Boot Clamp And Collector Cover Bracket Bolt
Courtesy of SUBARU OF AMERICA, INC.
Remove the air intake boot from the throttle body and the air cleaner case (rear), and move it to the left side wheel apron.
CAUTION: Be careful not to allow the air intake boot to contact the air conditioner pipe.

Fig 3: Removing Air Intake Boot From Throttle Body And Rear Air Cleaner Case
Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel pipe protector RH.

Fig 4: Locating Fuel Pipe Protector RH Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the pulsation damper RH from the fuel injector pipe RH.
CAUTION:
- Be careful not to spill fuel.
- Catch the fuel from the pipes using a container or cloth.
Fig 5: Locating Pulsation Damper RH
Courtesy of SUBARU OF AMERICA, INC.