LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2018 >> BRZ tS >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Control System >> Main Body ECM >> Customize Function
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Function

  1. Customization using the SSM4
    1. The following procedure can be used to check or set customization.
      1. Connect the SSM4 to the DLC3.
      2. Turn the ignition switch to ON.
      3. Turn on the SSM4.
      4. Enter the following menu.

        [Each System] →[Body Control] →[Customize] 

      5. Customize the settings according to the table below.
    LIST OF CUSTOMIZATION ITEMS

    Displayed name Initial value setting Contents Setting
    [Light Auto OFF Delay] 30 s Setting of lighting time for light auto cut function OFF, 30 s, 60 s or 90 s
    [Welcome Light Off Delay Time (Approaching)] 30 s Setting of lighting time for welcome light function (entering the vehicle) OFF, 30 s, 60 s or 90 s
    [Auto Dimmer Cancel Setting] 3 Setting of auto dimmer cancel function 0 (OFF)/stage 1 (least sensitive)/stage 2 (less sensitive)/stage 3 (standard)/stage 4 (more sensitive)/stage 5 (very sensitive)
    [Wiper Link Auto Light Setup] ON Switching of auto light function linked to wipers ON/OFF ON or OFF
    [Lane Change Signal Setting] ON Switching of lane change signal function ON/OFF ON or OFF
    [Auto Light Sensitivity] ±0% Auto light control sensor sensitivity (illumination detection) adjustment function settings (1) -40%/-20%/±0%/+20%/+40%
    Displayed name Initial value setting Contents Setting
    [DRL Function(2)] ON ON/OFF of the DRL function ON or OFF
    [Rear defogger operation mode] Normal Rear defogger operation drive mode settings Normal (3)/Continuous (4)
    [Lighting Time] 15 s Settings so that when the interior lamp is set to "DOOR", the interior lamp automatically turns off after all doors are closed 15 s/7.5 s/30 s
    [I/L when ACC OFF] support Settings so that when the interior lamp is set to "DOOR", the interior lamp automatically turns on when the vehicle changes from ACC ON →OFF support/no support
    [I/L ON W/Door Key Unlock] support Set the function to automatically turn on the interior light in accordance with unlocking operation using a smart key or mechanical key, when the interior light is set to the DOOR mode support/no support
    [Room Light when Approached] support Set the function to turn on the interior light when the driver approaches the vehicle carrying the smart key. support/no support
    [Interior Light Control] support Settings for the function where the interior lamp turns on by the timer support/no support
    [Security System] no support Auto alarm system function settings support/no support
    [Keyless Control] Yes Settings for the function that allows you to select to lock the door via operation of the electrical key transmitter SUB-ASSY (Electronic key) Yes or NO
    [Wireless Buzzer Resp] ON Wireless door lock buzzer response OFF or ON
    [Hazard Answer Back] ON When the wireless lock switch of the transmitter is pressed, all hazard warning lights are illuminated simultaneously. All hazard warning lights illuminate twice when the unlock switch is pressed. OFF or ON
    [Open Door Warning] ON The buzzer sounds when the lock is pressed while any door is open. OFF or ON
    [Unlocking operation] Yes Settings for the function where all doors are unlocked when the electrical key transmitter SUB-ASSY (Electronic key) is operated twice Yes or NO
    [Panic Alarm Function] ON Function to activate the anti-theft system when the panic switch of the electrical key transmitter SUB-ASSY is held down for 1.5 seconds or more. OFF or ON
    [Wireless Auto Lock] ON This function turns the wireless auto lock to ON or OFF. OFF or ON
    [Auto Lock Time] 60 seconds This function controls the time from unlocking all doors until the activation of auto lock function. 30 s, 60 s, 120 s
    [Trunk lid unlocking operation] Long press (short) Settings for the method of operation when opening the trunk with the electrical key transmitter SUB-ASSY (Electronic key) single press/2 times ON/Long press(short)/Long press(long)
    [Wireless Buzzer Volume] Level 5 Wireless door lock buzzer volume Level 7, Level 6, Level 5, Level 4, Level 3, Level 2, Level 1, or Level 0
    [Vehicle Finder Function] OFF Vehicle position display settings ON/OFF
    [Destination Setting] Changes depending on the destination Area settings Japan/North America/CAN/EU LHD/EK/CHN/KOR/UNI
    [SUBARU/Toyota setting] Toyota Manufacturer settings SUBARU/Toyota
    [Auto A/C setting] support Automatic air conditioner function settings support/no support
    [Halogen/HID setting(5)] HID Head light system function settings Halogen/HID setting(5)
    [MT/AT Setting] AT Transmission type settings MT/AT
    [Factory initial setting] Factory Mode to confirm customize settings Market/Factory
    [Initialization of function setting] - Customize function initialization -
    (1) As the setting is higher, the light turn on more easily.

    (2) Only displayed in the U.S. model.

    (3) Rear defogger operation turns OFF after 15 minutes.

    (4) Rear defogger operation repeats on a 2 minutes OFF, 15 minutes ON pattern.

    (5) The LED headlight is set on the HID display.
    NOTE:
    • The above settings are to be matched to particular vehicle equipment specifications.
    • Do not change any other settings other than the above items when performing function configuration.
    • Confirm that the main body ECM (Network gateway computer) registration content [Factory initial setting] is for the correct market. When it is in factory mode, this means that the settings have not been confirmed.
scientia non olet · About LEMON Manuals