Engine Control Computer (FA20): Installation

Installation of engine control computer bracket
1. Replace the bracket with a new one, engage 2 claws, and attach the engine control computer bracket to the engine control computer.
  CAUTION:
  - After attaching the engine control computer bracket to the engine control computer, do not remove the engine control computer bracket.
  - If the engine control computer bracket has been installed to the engine control computer in the wrong direction, replace the engine control computer bracket with a new one.
2. Installation of engine control computer
  CAUTION:
  - If the engine control computer for model with immobilizer is replaced, be sure to register the immobilizer system.
  - When replacing the engine control computer, do not use the one with a wrong specification.
  1. Using 2 nuts, install the engine control computer.
    Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
  2. Connect 4 connectors for engine control computer.
3. Installation of control module relay ASSY (without smart entry) (Refer to KEY LOCK UNIT )
4. Installation of glove compartment door ASSY (Refer to INSTALLATION , Step 3)
5. Installation of the instrument side panel RH (Refer to INSTALLATION , Step 7)
6. Connection of the battery ground terminal
  Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}