M/T Clutch System: Flywheel: Installation

Press-in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016in) deeper than that.
CAUTION: Do not press the bearing inner ring.

Courtesy of SUBARU OF AMERICA, INC.
Temporarily install the crankshaft position sensor plate and flywheel.
NOTE: Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.
Install the ST.
Special tool:

ST: 498497100 CRANKSHAFT STOPPER

Courtesy of SUBARU OF AMERICA, INC.
Tighten the flywheel mounting bolts in two stages.
1. Tighten the flywheel attachment bolts.
  Tightening torque:
  
  30 N.m (3.1kgf-m, 22.1ft-lb)
  
  Fig 1: Flywheel Mounting Bolts Tightening Sequence
  Courtesy of SUBARU OF AMERICA, INC.
2. While checking the tightening angle with the angle gauge, further tighten the flywheel mounting bolts.
  Tightening angle:
  
  30°-35°
Install the clutch disc and clutch cover. Ref. to CLUTCH SYSTEM>Clutch Disc and Cover>INSTALLATION .
Install the manual transmission assembly.
- 6MT model:
  Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>Manual Transmission Assembly>INSTALLATION .