LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2018 >> Outback 2.5i >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control/Fuel System (H4DO) >> Oil Control Solenoid >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oil Control Solenoid: Installation

  1. Install the intake oil control solenoid to the chain cover, and connect the connector to the intake oil control solenoid.
    NOTE:
    • Use new O-rings.
    • Apply engine oil to O-ring.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

  2. Install the air intake duct. (RH side only) Ref. to INTAKE (INDUCTION) (H4DO)>Air Intake Duct>INSTALLATION
  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
scientia non olet · About LEMON Manuals