VDC Control Module Parameter Check

NOTE: The parameter data registered in the VDC CONTROL MODULE is shown on the display.

Perform confirming on parameter.
1. Connect the Subaru Select Monitor.
  NOTE: For detailed operation procedures, refer to "Application Help".
2. Turn the ignition switch to ON.
3. On «Start» display, select «Diagnosis».
4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
5. On «Main Menu» display, select «Each System».
6. On «Select System» display, select «Brake Control System» and select «Enter».
7. On «Select Function» display, select «Work Support».
8. On «Work Support» display, select «Confirm on parameter».
Check that the applied model and grade of the relevant vehicle are included, and click the «OK» button.
If the applied model and grade of the target vehicle are not included, perform "parameter selection and registration". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDC CONTROL MODULE & H/U)>MAINTENANCE MODE>VDC CONTROL MODULE PARAMETER SELECTION .