LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2018 >> WRX Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamics Control System >> VDC Control Module And Hydraulic Control Unit (VDC CONTROL MODULE & H/U) >> Maintenance Mode >> VDC Control Module Parameter Selection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

VDC Control Module Parameter Selection

NOTE:
  • When the VDC CONTROL MODULE & H/U is replaced with a replacement part, be sure to perform the parameter selection/registration to the VDC CONTROL MODULE & H/U using this function.
  • To check the applied model, refer to the "Model Number Plate" attached to the vehicle. Ref. to IDENTIFICATION .
  • If you entered a wrong applied model, you can re-write it.
  • When the registration has not been performed, the DTC code "Parameter" is detected together with the ABS/EBD/VDC warning light illumination.
  • This function can be used for the replacement part of VDC CONTROL MODULE & H/U.
  1. Perform selection of parameter.
    1. Connect the Subaru Select Monitor.
      NOTE: For detailed operation procedures, refer to "Application Help".
    2. Turn the ignition switch to ON.
    3. On «Start» display, select «Diagnosis».
    4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
    5. On «Main Menu» display, select «Each System».
    6. On «Select System» display, select «Brake Control System» and select «Enter».
    7. On «Select Function» display, select «Work Support».
    8. On «Work Support» display, select «Selection of Parameter».
  2. Check the applied model and option code indicated on the "Model number plate". Ref. to IDENTIFICATION .
  3. Enter the applied model of 7-digit alphanumeric characters and press the «Enter» key.
  4. When the option code input screen appears after entering the applied model, enter the option code consisting of 4-digit alphanumeric characters, and press the «Enter» key. When the option code is 3 digits, add "0" (zero) in front and enter the code as 4 digits.
  5. When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the «OK» button.
    NOTE: When the displayed applied model and grade are different from those of the vehicle, perform registration operations after clicking the [OK] button.
  6. Execute the Clear Memory Mode after parameter selection and registration operations because the DTC for "Parameter selection error" is memorized. Ref. to VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)>Clear Memory Mode .
scientia non olet · About LEMON Manuals