VDC Control Module Parameter Writing

Perform writing of parameter.
1. Connect the Subaru Select Monitor.
  NOTE: For detailed operation procedures, refer to "Application Help".
2. Turn the ignition switch to ON.
3. On «Start» display, select «Diagnosis».
4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
5. On «Main Menu» display, select «Each System».
6. On «Select System» display, select «Brake Control System» and select «Enter».
7. On «Select Function» display, select «Work Support».
8. On «Work Support» display, select «Writing of parameter: SSM to ECM».
Open the file saved in the «Reading of parameter: ECM to SSM» procedure.
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the «OK» button.