Rack Housing Assembly

Disconnect the four pipes from gearbox.
NOTE: Remove the pipes C and D, which are fixed to clamp plate, as a unit.
Secure the gearbox removed from vehicle in a vise using ST.
CAUTION: Using the ST, secure the gearbox assembly in a vise as shown in the figure. Do not secure the gearbox without this ST.

Preparation Tool:

ST1: STAND (926200000)

ST2: BOSS D (34199AG000)
Remove the tie-rod end and lock nut from gearbox.
Remove the small clip from the boot using pliers, and then move the boot to tie-rod end side.
Using a flat tip screwdriver, remove the band from boot.
NOTE: Replace the boot if there is damage, cracks or deterioration.
Using the ST, loosen the lock nut.
Preparation Tool:

ST: SPANNER (926230000)
Tighten the adjusting screw until it can no longer be tightened.
Remove the tie-rod.
Loosen the adjusting screw, and remove the spring and sleeve.
Remove the two bolts securing valve assembly.
Carefully draw out the input shaft and remove the valve assembly.
Using a drill, release the crimping of holder.
CAUTION: Make a hole of 2 mm (0.08 in) depth using a drill with 3 mm (0.12 in) diameter.
Remove the holder.
Attach the ST on the valve side of rack, and press out the rack together with the outer side oil seal while taking care that the rack and the steering body inner surface do not come into contact with each other.
Preparation Tool:

ST: INSTALLER & REMOVER (34199XA030)

NOTE: Block the pipe connection of steering body to prevent fluid from flowing out.
Insert the ST from pinion housing side and remove the oil seal and back-up ring using a press.
Preparation Tool:

ST: OIL SEAL REMOVER (34099PA010)
Using a press, remove the bushing of gearbox installation portion.