LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Ascent Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Diagnostics - Introduction) >> Inspection Mode >> Procedure >> Inspection Mode S
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Mode S

DTC Item Condition Number of driving cycles on the detecting condition
P0033 TURBOCHARGER/SUPERCHARGER BYPASS VALVE "A" CONTROL CIRCUIT - 1
P1378 PRE-IGNITION DETECTED - 1
WARNING: When performing inspection mode S on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.
NOTE: Perform the inspection mode after warming up the engine except that the engine coolant temperature at engine start is specified.
  1. Using the Subaru Select Monitor, clear the memory of [Engine Control System]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
  2. Drive 3 times according to the drive pattern described below.
    G13202318Courtesy of SUBARU OF AMERICA, INC.
  3. Read the temporary code using the Subaru Select Monitor or general scan tool. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .