LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Ascent Base >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag System >> Airbag Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Airbag Control Module: Installation

  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • Control module is deformed.
    • Control module connector is damaged.
  2. Install the airbag control module.
    CAUTION: Do not reuse the bolt and nut.
    Always replace with the specified new bolts and nuts.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

  3. Install the cover center socket.
  4. Install the cover center side.
  5. Install the console box assembly and the cover assembly front.

    Tightening torque: 

    Console box: 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)

  6. Install the heater control assembly.
  7. Install the audio assembly or navigation assembly.
  8. Install the switch assembly hazard.
  9. Install the grille ventilation assembly center.
  10. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: After connecting the battery ground terminal, place the select lever in the "P" position.
scientia non olet · About LEMON Manuals