AT Shift Lock Solenoid and "P" Range Switch: Inspection

Measure the resistance of solenoid unit connector terminals.

Terminals

No. 4 - No. 3:

Is the resistance 27.6 - 30.5 Ω?

Yes  : Go to  2.

No  : Replace the solenoid unit. Ref. to CONTROL SYSTEMS>AT SHIFT LOCK SOLENOID AND "P" RANGE SWITCH>REMOVAL .

Connect the battery to the solenoid unit connector terminals, and then operate the solenoid.

Terminals

No. 3 (+) - No. 4 (-):

Does the solenoid unit operate normally?

Yes  : Go to  3.

No  : Replace the solenoid unit. Ref. to CONTROL SYSTEMS>AT SHIFT LOCK SOLENOID AND "P" RANGE SWITCH>REMOVAL .

1. Shift the select lever to "P" range.
2. Measure the resistance between "P" range switch connector terminals.

Terminals

No. 1 - No. 2:

Is the resistance less than 1 Ω?

Yes  : Go to  4.

No  : Replace the AT select lever COMPL. Ref. to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .

1. Set the select lever to other than "P" range.
2. Measure the resistance between "P" range switch connector terminals.

   Terminals

   No. 1 - No. 2:

Is the resistance 1 MΩ or more?

Yes  : Normal.

No  : Replace the AT select lever COMPL. Ref. to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .