Oil Control Solenoid: Installation: Intake

RH SIDE.
1. Using a new O-ring, install the oil control solenoid.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
2. Connect the connector.
3. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR INTAKE DUCT>INSTALLATION .
4. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
LH SIDE.
1. Using a new O-ring, install the oil control solenoid.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
2. Connect the connector.
3. Hold the engine wiring harness with the clip.
4. Install the reservoir tank. Ref. to COOLING (H4DOTC)>RESERVOIR TANK>INSTALLATION .
5. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .