Fuel Pressure Sensor (FA20): Installation
- Fuel injector ASSY installation (Refer to
INSTALLATION )CAUTION: Use a new fuel delivery pipe (bank 1 side).
- Fuel delivery pipe (bank 1 side) and fuel pressure sensor installation
- Install the fuel delivery pipe (bank 1 side) with the two bolts.
Standard value: T=19Nm {194kgfcm} {14.0ftlbf}
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe (bank 1 side) until it can be turned by hand.
- Fuel the fuel pressure sensor.
Standard value: T=46Nm {469kgfcm} {33.9ftlbf}
CAUTION:- There must be no oil on the threaded portions of fuel pressure sensor and fuel delivery pipe (bank 1 side).
- Do not allow foreign matter to get in when installing the fuel pressure sensor.
- Do not retighten (or recheck the tightening torque of) the fuel pressure sensor after it is tightened once.
- Connect the two fuel injector connectors and fuel pressure sensor connector.
- Install the fuel delivery pipe (bank 1 side) with the two bolts.
- Fuel delivery pipe installation
- Temporarily tighten the nut for the new fuel delivery pipe until it is seated.
- Temporarily install the fuel delivery pipe with the three bolts.
- Tighten the three bolts.
Standard value: T=6.4Nm {65kgfcm} {4.7ftlbf}
- Tighten the fuel delivery pipe.
Standard value: T=25Nm {255kgfcm} {18.4ftlbf}
- Intake manifold installation (Refer to INSTALLATION )