VDCCM Parameter Check

NOTE: The parameter data registered in the VDCCM is shown on the display.

Perform confirming on parameter.
1. Connect the Subaru Select Monitor.
  NOTE: For detailed operation procedures, refer to "Help" of application.
2. Turn the ignition switch to ON.
3. On [Start] screen, select [Diagnosis].
4. On [Select Vehicle] screen, input the target vehicle information and select [Set].
5. On [Main Menu] screen, select [Each System].
6. On [Select System] screen, select [Brake Control], and then select [Enter].
7. On [Select Function] screen, select [Work Support].
8. On [Work Support] screen, select [Confirm on parameter].
Check that the applied model and grade of the target vehicle are included, and click the [OK] button.
If the applied model and grade of the target vehicle are not included, perform "parameter selection and registration". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM&H/U)>MAINTENANCE MODE>VDCCM PARAMETER CHECK .