Air Cleaner Case: Installation
- Install the air cleaner case bracket and install the cushion.NOTE: Align the protrusion of the cushion with the cutout portion on the air cleaner case bracket.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the air cleaner case (front).
Tightening torque:
Bolt
6 N.m (0.6 kgf-m, 4.4 ft-lb)
Nut
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Set the air cleaner element and install the air cleaner case (rear).CAUTION: Install the air cleaner element so that the printed surface is on the upper side.NOTE:
- If any foreign matter is found in the air cleaner case, clean it.
- Install by aligning the claws located on the bottom of the air cleaner case.
- Connect the air intake boot.
Tightening torque:
3 N.m (0.3 kgf-m, 2.2 ft-lb)
- Connect the connector to the mass air flow and intake air temperature sensor, and secure the harness with clip.
- Install the air intake duct.
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .