Belt Assembly Front Inn

CAUTION:

Before installation, make sure that the correct part is used.
During installation, make sure that the seat belts are not twisted.
Check that there is no pinching of the seat belt harness. Wrong harness rooting may cause the harness short from pinch.
Do not forget the spring wave washer, when installing the belt assembly front INN.
If the passenger's seat is removed, be sure to perform [Rezero] for the occupant detection system after installing the seat to the vehicle.

Install the belt assembly front INN.

Install the wave washer, belt assembly front INN and nut in order and then tighten the nut.
Tightening torque:

38 N.m (3.9 kgf-m, 28.0ft-lb)

Locate the seat belt harness and retain it with a harness clip.

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

NOTE: For details about harness routing behind the seat, refer to "SEATS" information. Ref. to SEATS>FRONT SEAT>ASSEMBLY>CONNECTOR & HARNESS .

Install the seat assembly to the body. Ref. to SEATS>FRONT SEAT>INSTALLATION .
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
If the passenger's seat is removed, make sure to perform [Rezero] in the occupant detection system. Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>REZERO .