Select Lever: Removal
- Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Release the shift lock using a screwdriver, etc. and shift the select lever to the "N" range.
- Remove the center exhaust cover.
- Remove the select cable from the transmission body.CAUTION: Do not apply excessive load while holding the part (a).
- Lower the grip cover vertically. (Model with gate shifter)
- Lower the boot vertically. (Model with boot shifter)
- Remove the clamp.
- Remove the grip.
- Remove the duct console center. Ref. to AIR CONDITIONER>AIR VENT DUCT>REMOVAL>CONSOLE DUCT>CENTER .
- Remove the harness.
- Disconnect the connector.
- Remove the select lever.CAUTION: Be careful not to apply a load to the select cable.
- Disconnect the select cable. Ref. to CONTROL SYSTEMS>SELECT CABLE>REMOVAL .