April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oil Control Solenoid: Installation: Intake

RH SIDE
1. Install the backup ring to the oil control solenoid.
2. Using a new O-ring, install the oil control solenoid.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
3. Connect the connector.
4. Install the air intake duct (rear). Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE DUCT>INSTALLATION .
5. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
LH SIDE

Install the backup ring to the oil control solenoid.
Using a new O-ring, install the oil control solenoid.
NOTE: Apply engine oil to O-ring.

Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Connect the connector.
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .