LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Outback 2.5i Limited >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (2.5L) >> Camshaft Position Sensor >> Inspection >> Camshaft Position Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Camshaft Position Sensor

  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Prepare an oscilloscope.
  3. While pressing the section (A) shown in the figure, move the lock lever (B) in the direction of the arrow to disconnect the connectors from the ECM in numerical order as shown in the figure.
    Fig 1: ECM Bolts Loosening Sequence
    G10262110Courtesy of SUBARU OF AMERICA, INC.
  4. Attach the ST between the ECM, engine wiring harness and the bulkhead wiring harness. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>GENERAL DESCRIPTION>CAUTION .

    ST 18460AA050 CHECK BOARD 

  5. Connect the probe to ST.
    G12403293Courtesy of SUBARU OF AMERICA, INC.
    Camshaft position sensor Terminal No. Probe
    RH 54 +
    LH 41 +
    RH and LH 63 -
  6. Start the engine and let it idle.
  7. Check the waveforms and voltage.
    NOTE: For waveform and voltage, refer to "Engine Control Module (ECM) I/O Signal". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>ENGINE CONTROL MODULE (ECM) I/O SIGNAL>ELECTRICAL SPECIFICATION .
  8. After inspection, install the related parts in the reverse order of removal.
scientia non olet · About LEMON Manuals