Drive Cycle X
| DTC | Item | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P2004 | TGV CONTROL STUCK OPEN BANK 1 | - | 1 |
| P2005 | TGV CONTROL STUCK OPEN BANK 2 | - | 1 |
| P2006 | TGV CONTROL STUCK CLOSED BANK 1 | - | 1 |
| P2007 | TGV CONTROL STUCK CLOSED BANK 2 | - | 1 |
- Using the Subaru Select Monitor, perform the clear memory for «Engine». Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>CLEAR MEMORY MODE>OPERATION .
- Idle the engine for 10 seconds or more after engine start.
- For CVT models, set the select lever to "P" range, and for MT models, move the gear shift lever into neutral position, and then race the engine for 10 seconds or more.NOTE: Keep the engine speed at 3500 rpm or more.
- Read the temporary code using the Subaru Select Monitor or general scan tool. Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>READ DIAGNOSTIC TROUBLE CODE (DTC)>OPERATION .