LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Ascent Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle >> AT learning >> Procedure >> At Learning Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

At Learning Mode

NOTE: AT learning mode is performed with the vehicle lifted, without actually running the vehicle.
  1. On «Start» screen, select «Diagnosis».
  2. On «Vehicle selection» screen, input the vehicle information and select «Confirmed».
  3. On «Main Menu» screen, select «Each System».
  4. On «Select System» screen, select «Transmission Control System».
  5. On «Select Function» screen, select «Work Support».
  6. On «Work Support» screen, select «AT learning mode».
  7. Follow the messages displayed on the screen when working.
  8. When «AT learning normally ended.» is displayed, AT learning mode is completed.
NOTE:
  • If communication error occurs during learning, retry the "AT learning mode" from the beginning.
  • If the message «Execute AT learning again after fixing troubles of the vehicle» appears during learning, select «OK» and display the DTC list. After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.
  • When communication error occurs during learning, select lever does not shift occasionally. If select lever does not shift, turn the ignition switch to OFF before operating the select lever.
  • If the message «AT learning ended abnormally. Try again from the beginning.» is displayed, start the "AT learning mode" over from the beginning.
Display Main causes for abnormal termination
«AT learning ended abnormally. Try again from the beginning.»
  • Fault is detected during AT learning.
  • The accelerator pedal is depressed during AT learning.
  • An unspecified operation was performed during AT learning
  • ATF temperature becomes out of specification during AT learning.
  • Battery voltage is low.
  • The malfunction indicator light is lit.
  • Electric parking brake not applied strongly enough
  • Brake pedal is not fully depressed.
  • Abnormal idle speed increase, etc.
scientia non olet · About LEMON Manuals