LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Ascent Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle >> AT learning >> Procedure >> Preparation For Learning
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preparation For Learning

  1. Connect the Subaru Select Monitor.
  2. Turn the ignition switch to ON. (Engine OFF)
  3. Display [ATF Temp.].
  4. Warm up or cool down until [ATF Temp.] displayed on the Subaru Select Monitor is 40 - 65°C (104 - 149°F).
  5. After stopping the vehicle, shift the select lever to "P range".
  6. Apply the parking brake.
  7. Turn the ignition switch to OFF.
  8. Lift up the vehicle.
    CAUTION: While working, be sure to keep the lower edge of the tires 30 cm or more above the ground as vehicle will vibrate.
  9. Turn the ignition switch to ON.
  10. Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger, etc.
scientia non olet · About LEMON Manuals