Secondary Pressure Sensor: Installation
CAUTION:
- If water or oil contacts the connector terminal of secondary pressure sensor, replace it with a new part.
- If CVTF has leaked when the secondary pressure sensor is removed, adjust the CVTF level after installing the secondary pressure sensor.
- Install the secondary pressure sensor using a new O-ring.CAUTION:
- Before installing O-rings, apply sufficient amount of CVTF to avoid damage and deformation.
- Use SUBARU genuine CVTF.
- Be careful not to incorrectly install or fail to install O-rings and other such parts.
Tightening torque:
39 N.m (4.0 kgf-m, 28.8 ft-lb)
- Connect the secondary pressure sensor harness connector.
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .