LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission Control System >> Select Cable >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Removal

  1. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: For the hybrid model, disconnect the battery negative terminal.
  2. Shift the select lever to "N" range.
  3. Lift up the vehicle.
  4. Remove the center exhaust cover.
    • Except for Crosstrek hybrid model
      G13230505Courtesy of SUBARU OF AMERICA, INC.
    • Crosstrek hybrid model
    G13230506Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the inhibitor cover. (Crosstrek hybrid model)
    G13232270Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the select cable from the transmission main body.
    CAUTION: Do not apply excessive load while holding the part (a).
    G13591814Courtesy of SUBARU OF AMERICA, INC.
    • Except for Crosstrek hybrid model
      G13225470Courtesy of SUBARU OF AMERICA, INC.
    • Crosstrek hybrid model
    G13232273Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the cable from arm COMPL.
    CAUTION: Do not apply excessive load while holding the part (a).
    G13591854Courtesy of SUBARU OF AMERICA, INC.
    G13602903Courtesy of SUBARU OF AMERICA, INC.
  8. Raise the claw of clamp to remove the cable from bracket.
    G13602904Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the select cable from the cable plate.
scientia non olet · About LEMON Manuals