LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (Except For HEV) >> Fuel Tank >> Installation >> Impreza Model
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Impreza Model

  1. Install the fuel tank band bracket.

    Tightening torque: 

    37 N.m (3.8 kgf-m, 27.3 ft-lb)

    G11252931Courtesy of SUBARU OF AMERICA, INC.
  2. Support the fuel tank with a transmission jack, set the fuel tank in place, and temporarily tighten the bolts of the fuel tank band.
    CAUTION: A helper is required to perform this work.
    G11252930Courtesy of SUBARU OF AMERICA, INC.
  3. Tighten the bolts of the fuel tank band in the numerical order shown in the figure.

    Tightening torque: 

    33 N.m (3.4 kgf-m, 24.3 ft-lb)

    Fig 1: Fuel Tank Band Bolts Tightening Sequence
    G11252934Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the fuel delivery tube to the fuel pipe assembly. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE A) .
    G11252929Courtesy of SUBARU OF AMERICA, INC.
  5. Connect the vent tube (A) to the canister. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE F) .
  6. Connect the circulate tube (B) to the fuel tank. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE D) .
    G11252928Courtesy of SUBARU OF AMERICA, INC.
  7. Connect the fuel filler hose to the fuel filler pipe assembly. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>FUEL FILLER HOSE CONNECTION .
    G11252927Courtesy of SUBARU OF AMERICA, INC.
  8. Install the rear differential.

    VA-type: 

    Refer to DIFFERENTIALS>REAR DIFFERENTIAL (VA-TYPE)>INSTALLATION .

    VB-type: 

    Refer to DIFFERENTIALS>REAR DIFFERENTIAL (VB-TYPE)>INSTALLATION .

  9. Install the rear exhaust pipe and muffler.

    Rear exhaust pipe: 

    Refer to EXHAUST (H4DO (EXCEPT FOR HEV))>REAR EXHAUST PIPE>INSTALLATION .

    Muffler: 

    Refer to EXHAUST (H4DO (EXCEPT FOR HEV))>MUFFLER>INSTALLATION .

  10. Install the fuel tank protector. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL TANK PROTECTOR>INSTALLATION .
  11. Lower the vehicle.
  12. Connect the connector to the fuel pump.
    CAUTION: Before connecting, make sure that there are no foreign matters, water, etc. inside the connectors of fuel pump and harness. If any foreign matters, water, etc. are found, remove them with air blow and connect the connector after it has dried completely.
    G11252926Courtesy of SUBARU OF AMERICA, INC.
  13. Install the service hole cover of fuel pump.
    G11252925Courtesy of SUBARU OF AMERICA, INC.
  14. Install the rear seat cushion. Refer to SEATS>REAR SEAT>INSTALLATION .
  15. Connect the ground terminal to 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals