LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Auto Start Stop System (Diagnostics) >> Inspection Mode >> Procedure >> Preparation For The Inspection Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preparation For The Inspection Mode

  1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
  2. Check that the front hood is closed.
  3. Start and warm up the engine.
  4. Using the Subaru Select Monitor, read the data of Auto Start Stop and check that [ECM Idle Stop Prohibition] and [CVT idle stop prohibition] indicate "Permit". Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR .
  5. Using the Subaru Select Monitor, perform the clear memory of [Auto Start Stop]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
  6. Read the diagnostic trouble code (DTC) and check that no DTC is displayed. Ref. to AUTO START STOP (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". Ref. to AUTO START STOP (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . After solving the DTC, repeat from step  2.
  7. Turn the ignition switch to OFF.
scientia non olet · About LEMON Manuals