VDCCM Parameter Check

NOTE: The parameter data registered in the VDCCM is shown on the display.

Perform confirming on parameter.
1. Connect the Subaru Select Monitor.
2. Turn the ignition switch to ON.
3. On [Start] screen, select [Diagnosis].
4. On [Select Vehicle] screen, input the target vehicle information and select [Set].
5. On [Main Menu] screen, select [Each System].
6. On [Select System] screen, select [Brake Control], and then select [Enter].
7. On [Select Function] screen, select [Work Support].
8. On [Work Support] screen, select [Confirm on parameter].
Check that the applied model and grade of the target vehicle are included, and click the [OK] button.
If the applied model and grade of the target vehicle are not included, perform "parameter selection and registration". Refer to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>MAINTENANCE MODE>VDCCM PARAMETER CHECK .