High-Pressure Fuel Delivery Pipe
- Temporarily tighten the flare nut of the high-pressure fuel delivery pipe by hand until it seats, and tighten the flare nuts on both ends.CAUTION:
- Always use a new high-pressure fuel delivery pipe.
- Check that the seal surface of the fuel injector pipe LH and the high-pressure fuel pump have no deformation, cracks or other damages.
- Check that the seal surface of the fuel injector pipe LH and the high-pressure fuel pump have no foreign materials.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Install the fuel pipe insulator No. 3.
Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>FUEL INSULATOR>INSTALLATION .
- Install the intake manifold assembly.
Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>INTAKE MANIFOLD ASSEMBLY>INSTALLATION .
- Install the air intake boot.
Refer to INTAKE (INDUCTION) (H4DO)>AIR INTAKE BOOT>INSTALLATION .
- Install the collector cover.
Refer to INTAKE (INDUCTION) (H4DO)>COLLECTOR COVER>INSTALLATION .
- Connect the ground terminal to battery sensor.
Refer to REPAIR CONTENTS>NOTE>BATTERY .