High-Pressure Fuel Pump

Install the fuel pump lifter.
NOTE:
- Apply engine oil to the side of the high-pressure fuel pump case and to the bottom surface of the fuel pump lifter.
- After installing the fuel pump lifter, rotate the crankshaft in order to set the fuel pump lifter to the lowest position.
Courtesy of SUBARU OF AMERICA, INC.
Set a new O-ring, and install the high-pressure fuel pump using TORX PLUS® 40IP.
Tightening torque:

21 N.m (2.1 kgf-m, 15.5 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Connect the connector.

Courtesy of SUBARU OF AMERICA, INC.
Install the high-pressure fuel delivery pipe.
Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>HIGH PRESSURE FUEL DELIVERY PIPE>INSTALLATION>HIGH-PRESSURE FUEL DELIVERY PIPE .
Install the air intake boot.
Refer to INTAKE (INDUCTION) (H4DO)>AIR INTAKE BOOT>INSTALLATION .
Install the collector cover.
Refer to INTAKE (INDUCTION) (H4DO)>COLLECTOR COVER>INSTALLATION .
Connect the ground terminal to battery sensor.
Refer to REPAIR CONTENTS>NOTE>BATTERY .