Fuel Injector LH
CAUTION:
- Be careful not to spill fuel.
- Catch the fuel from the pipes using a container or cloth.
- Disconnect the ground terminal from battery sensor.
Refer to REPAIR CONTENTS>NOTE>BATTERY .
- Remove the collector cover.
Refer to INTAKE ((INDUCTION) (H4DO)>COLLECTOR COVER>REMOVAL .
- Remove the clip from the air intake boot, and loosen the clamp.
- Remove the air intake boot, and place it aside so that it does not interfere with the work.CAUTION: Be careful not to pull out the PCV hose.
- Remove the high-pressure fuel delivery pipe assembly.
- Remove the high-pressure fuel delivery pipes.
- Move the A/C compressor aside so that it does not interfere with the work.NOTE: This procedure is required to disconnect the fuel injector #2 connector.
- Remove the V-belts.
Refer to MECHANICAL(H4DO)>V-BELT>REMOVAL>V-BELT .
- Remove the bolt securing the A/C compressor.
- Move the A/C compressor as shown in the figure.CAUTION: Do not bend the pipe portion of the hose pressure discharge and the hose pressure suction.
- Remove the V-belts.
- Disconnect the connector (A) from the coupling harness and remove the clip (B).
- Disconnect the connector (C) from the fuel injector #2.
- Remove the fuel injector pipe LH together with the fuel injector.
- Disconnect the coupling harness from the fuel injector #4.
- Remove the fuel injector.