Auto Headlight Beam Leveler Control Module: Installation
CAUTION:
Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION
.
- Install the auto headlight beam leveler Control Module.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the duct foot driver. Refer to AIR CONDITIONER>Air Vent Duct>INSTALLATION>FOOT DUCT .
- Install the knee airbag module. Refer to AIRBAG SYSTEM>Knee Airbag Module>INSTALLATION .
- Install the cover LWR driver. Refer to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>INSTALLATION .
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
- Perform initialization and reinitialization of the auto headlight beam leveler system. Refer to LIGHTING SYSTEM>Auto Headlight Beam Leveler System>PROCEDURE .