| Alignment gauge |
Used for measuring wheel alignment. |
| Alignment gauge adapter |
Used for measuring wheel alignment. |
| Dial gauge |
Used for measuring the runout of strut COMPL front. |
| Magnet stand |
Used for measuring the runout of strut COMPL front. |
| Coil spring compressor |
Used for disassembling and assembling strut assembly and shock absorber assembly rear. |
| Shackle |
- Two units used for hanging power unit.
- Attached to both end of chain sling and connected to engine hook.
- Load capacity: 250 kg (551 lb) or more
|
| Sling belt |
- Used for removing and installing the crossmember COMPL front.
- Width: 35 - 40 mm (1.38 - 1.57 in)
- Length: 2 m (6.6 ft)
- Load capacity: 1 t (2205 lb) or more
|
| Wire rope |
- Used for connecting the shackle to hang power unit.
- Load capacity: 250 kg (551 lb) or more
|
| Ball joint puller |
Used for disconnecting ball joint and tie-rod end. |
| Turning radius gauge |
Used for measuring wheel alignment. |
| Toe-in gauge |
Used for toe-in measurement. |
| DST-i |
Used together with Subaru Select Monitor 4. |