Select Cable: Installation

Install the cable plate.
CAUTION: Be careful not to twist the boot.

Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Set a new clamp on the select lever and secure it by bending the claw.
NOTE: Set so that the claw faces toward the rear side.
Insert the select cable into the select lever and secure it with the clamp.
CAUTION: Do not apply excessive load while holding the part (a).

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Temporarily Install the adjusting nut (rear) to the select cable.
Connect the select cable to the transmission main body.
CAUTION: Do not apply excessive load while holding the part (a).

Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Adjust the select cable free play. Refer to CONTROL SYSTEMS>Select Cable>ADJUSTMENT .
Install the center exhaust cover.
2.5L model:

Refer to EXHAUST (H4DO)>Rear Exhaust Pipe>INSTALLATION .

2.4L model:

Refer to EXHAUST (H4DOTC)>Rear Exhaust Pipe>INSTALLATION .
Install the mat center tray.
Shift the select lever to "P range".
Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .