Steering Column: Installation
CAUTION:
- When removing, installing or replacing the VDC CONTROL MODULE & H/U, VDC CONTROL MODULE & H/U bracket, electronic power steering gearbox, steering wheel or steering angle sensor (steering roll connector), perform "VSC(VDC) Centering Mode" of the VDC. Refer to VEHICLE DYNAMICS CONTROL(VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
- Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Install the bushing to the toe board.
- Insert the end of the column assembly - steering into the toe board bushing.
- Tighten the column assembly - steering installation nut located under the beam COMPL - steering with the tilt lever fixed.
Tightening torque:
20 N.m (2 kgf-m, 14.8 ft-lb)
- Install the ignition key lock. Refer to SECURITY AND LOCKS>IGNITION KEY LOCK>REPLACEMENT .
- Install the switch assembly - combination.
- Connect all the connectors under the instrument panel.
- Install the universal joint assembly - steering. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>UNIVERSAL JOINT>INSTALLATION .CAUTION:
- Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.
- Be sure to follow the tightening order and tightening torque of the universal joint assembly - steering to avoid the steering effort from becoming heavy.
- Install the knee airbag module. Refer to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .
- Install the cover assembly - instrument panel LWR driver.
- Install the cover assembly - column.
- Align the center position of the steering roll connector. Refer to AIRBAG SYSTEM>ROLL CONNECTOR>ADJUSTMENT .
- Install the steering wheel.
Tightening torque:
Steering wheel: 39 N.m (4 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
- Install the driver's airbag module. Refer to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>INSTALLATION .
- Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .