LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> Ascent Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle System >> AT learning >> Procedure >> At Learning Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

At Learning Mode

NOTE: AT learning mode is performed with the vehicle lifted, without actually running the vehicle.
  1. On [Start] screen, select [Diagnosis].
  2. On [Vehicle selection] screen, enter vehicle information and select [Set].
  3. On [Main Menu] screen, select [Each System].
  4. On [Select System] screen, select [Transmission Control System].
  5. On [Select Function] screen, select [Work Support].
  6. On [Work Support] screen, select [AT learning mode].
  7. Follow the messages displayed on the screen when working.
  8. When [AT learning normally ended.] is displayed, AT learning mode is completed.
    NOTE:
    • If communication error occurs during learning, retry the "AT learning mode" from the beginning.
    • If the message [Execute AT learning again after fixing troubles of the vehicle] is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code.

      After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.

    • When communication error occurs during learning, select lever does not shift occasionally. If select lever does not shift, turn the ignition switch to OFF before operating the select lever.
    • If the message [AT learning ended abnormally. Try again from the beginning.] is displayed, start the "AT learning mode" over from the beginning.
    Display Main causes for abnormal termination
    [AT learning ended abnormally. Try again from the beginning.]
    • Fault is detected during AT learning.
    • The accelerator pedal is depressed during AT learning.
    • An unspecified operation was performed during AT learning
    • ATF temperature becomes out of specification during AT learning.
    • Battery voltage is low.
    • The malfunction indicator light is lit.
    • Parking brake is not applied hard enough.
    • Brake pedal is not fully depressed.
    • Abnormal idle speed increase, etc.
scientia non olet · About LEMON Manuals