LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> Ascent Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle System >> AT learning >> Procedure >> Preparation For Learning
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preparation For Learning

  1. Connect the Subaru Select Monitor.
  2. Turn the ignition switch to ON. (Engine OFF)
  3. Display [ATF Temp.].
  4. Warm up or cool down until [ATF Temp.] displayed on the Subaru Select Monitor is 40 - 65 °C (104 - 149 °F).
  5. After stopping the vehicle, shift the select lever to "P range".
  6. Apply the parking brake.
  7. Turn the ignition switch to OFF.
  8. Lift up the vehicle.
    CAUTION:
    • Lift up the vehicle until the tire bottom is 0.3 m (0.98 ft) or more above the ground.
    • Make sure that safety is secured where the tiers rotate.
  9. Turn the ignition switch to ON. (Engine OFF)
  10. Turn off all systems causing an electrical load, such as headlights, A/C, seat heater and rear defogger.
scientia non olet · About LEMON Manuals