Secondary Pressure Sensor: Installation

CAUTION: If water or oil contacts the connector terminal of secondary pressure sensor, replace it with a new part.

Install a new O-ring.
NOTE: Apply CVTF to the O-rings.
Using Ko-ken 3/8 12-point 27-mm deep socket (part No. 3305M-27), install the secondary pressure sensor and connect the connector.
Tightening torque:

39 N.m (4.0 kgf-m, 28.8 ft-lb)
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .