LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> Ascent Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle System >> Transmission Harness >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Harness: Installation

  1. Install a new O-ring.
    NOTE: Apply CVTF to the O-rings.
  2. Set the transmission harness, and install the clip.
  3. Install the bolt which holds the transmission harness.

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

  4. Install the control valve body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Control Valve Body>INSTALLATION .
  5. Remove the ST (STAND ASSY).
  6. Install the torque converter. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Torque Converter>INSTALLATION .
  7. Install the harness stay to the transmission harness connector and inhibitor harness connector.
  8. Connect the harness connectors to the inhibitor switch, secondary pressure sensor, primary speed sensor, front wheel speed sensor and secondary speed sensor.
  9. Connect the transmission ground.

    Tightening torque: 

    13 N.m (1.3 kgf-m, 9.6 ft-lb)

  10. Install the transmission body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Transmission Assembly>INSTALLATION .
scientia non olet · About LEMON Manuals