LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> Forester Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Power Rear Gate System >> Power Rear Gate Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Rear Gate Control Module: Removal

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  • Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to GROUND TERMINAL REMOVAL OR INSTALLATION .
  2. Remove the rear seat cushion assembly. Ref. to SEATS>REAR SEAT>REMOVAL .
  3. Remove the trim panel assembly apron LH and the trim panel assembly D pillar LH. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>REMOVAL .
  4. Remove the power rear gate control module.
    1. Disconnect the connectors in the following (a) - (c) order.
      G13227240Courtesy of SUBARU OF AMERICA, INC.
      NOTE: When the connectors are not disconnected in the sequence, a diagnosis code (DTC) may be detected.
    2. Release the lock and hook, and remove the power rear gate control module.
    G13227241Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals