Airbag Control Module: Installation

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .
Do not disassemble the airbag control module.
If the airbag control module is deformed or if there is any trace of water on the module, replace the airbag control module with a new one.
Do not drop the airbag control module.
After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.

Before installation, inspect the following items and replace any faulty part with a new part.
- Control module is deformed.
- Control module connector is damaged.
Install the airbag control module.
CAUTION: Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.

Tightening torque:

25 N-m (2.5 kgf-m, 18.4 ft-lb)
Install the duct console front and the tray center UPR as a unit.
Install the duct console center.
Install the cover center side on the left and right sides.
Install the cover assembly front and the console box assembly.
Tightening torque:

Console box: 6.5 N-m (0.7 kgf-m, 4.8 ft-lb)
Install the heater control assembly.
Connect the ground terminal to battery sensor. Ref. to GROUND TERMINAL REMOVAL OR INSTALLATION .
NOTE: After connecting the battery sensor terminal, place the select lever in the "P" position.