Check Abs Wheel Speed Sensor Unit

Visually check the tip of the sensor sub assembly rear for foreign particles or damage. If necessary, clean the tip or replace the sensor sub assembly rear.
Disconnect the sensor sub assembly rear connector.
Check insulation of the sensor sub assembly rear cable. Replace the sensor sub assembly rear if faulty.
Connect a 12 V power supply to No. 1 terminal of sensor sub assembly rear connector, then attach resistance to the No. 2 terminal. Rotate the wheel at about 2.75 km/h (2 MPH), and measure the voltage using an oscilloscope.
Standard value of output voltage:

0.7 - 1.4 V

Courtesy of SUBARU OF AMERICA, INC.
- If the inspection result shows that the output voltage is out of the standard value: Replace the magnetic encoder (rear hub unit bearing).
- If the inspection result shows that the output voltage is within standard value: Replace the hydraulic unit assembly VDC.